Congratulations on owning the ViewPlus Pro Gen II braille and
graphics embosser! This manual will introduce you to basic information
regarding your new printer. The ViewPlus Technologies web site is another
resource for information on your ViewPlus embosser including examples,
tutorials, and other useful downloads.
This
equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Note the following:
The length of the parallel interface cable must be 3 meters (10 feet) or less.
The use of a non-shielded interface cable with the referenced device is prohibited.
The length of the power cord must be 3 meters (10 feet) or less.
The length of the serial interface cable must be 15 meters (50 feet) or less.
COMPLIANCE STATEMENT (CANADA)
This digital apparatus is in conformity with standard NMB-003 of Canada.
Cet appareil numérique est conforme à la norme NMB-003 du Canada.
COMPLIANCE STATEMENT (GERMANY)
Bescheinigung des Herstellers/Importeurs:
Hiermit
wird bescheinigt, dass der Drucker der
Maschinenlärminformationsverordnung 3. GSGV, 18.01.1991 entspricht: Der
höchste Schalldruckpegel beträgt 70 dB(A) oder weniger gemäß EN27779-1991.
COMPLIANCE STATEMENT (EUROPE)
Warning:
This product meets the interference requirements of EN55022. In a
domestic environment, this product may cause radio interference in
which case, the user may be required to take adequate measures.
COMPLIANCE STATEMENT (KOREA)
This apparatus complies with CISPR22 requirement.
INTERNATIONAL COMPLIANCE
EN55022: 2006 + A1:2007 - Emissions series
EN55024:1998 - Immunity characteristics
EN61000-3-2:2006 - Power line harmonics
EN61000-3-3:1995 - Power line flicker
EN61000-4-2:1995 - Electrostatic discharge
EN61000-4-3:1995 - Radiated susceptibility
EN61000-4-4:1995 - Electrical fast transient/burst
EN61000-4-5:1995 - Surge
EN61000-4-6:1996 - Conducted immunity
EN61000-4-11:1994 - Input voltage interruptions/DIPS
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)
COMPLIANCE
ViewPlus BV complies with EU Directive 2002/96 regarding WEEE recycling; upon the
conclusion of the product lifecycle, please contact ViewPlus BV concerning proper disposal.
C.
Safety Instructions
Read all of these safety instructions before using the
printer. In addition, follow all
warnings and instructions marked on the printer itself.
Do not place printer on an unstable surface.
Do not place printer near a radiator or heat source.
Do not block or cover slots and openings in the printer's cabinet; do
not inset objects through slots.
Use only the type of power source indicated on printer's label.
Connect all equipment to properly grounded electrical outlets.
Do not use frayed or damaged power cord.
The use of an extension cord with the printer is not recommended.
Unplug printer before cleaning it; always clean it with a piece of damp
cloth only.
Do not spill liquid into printer.
Except as specifically explained in the user's manual, do not attempt
to service the printer by yourself.
Detach the printer from power source and refer to qualified service
personnel under the following conditions:
If the power cord or plug is
damaged
If liquid has entered the printer.
If printer has been dropped or the cabinet is damaged.
If the printer does not operate properly or exhibits a distinct change
in performance.
Only adjust those controls that are covered by the operating
instructions.
D.
Specifications
Character
Sets
DotsPlus
Braille ( U.S.
Standard, German,
Italian, French, Spanish )
Paper
Feed Method
front
load continuous form
front load single sheet feed
stack sheet feeder optional (no longer available for purchase)
English
Français
Svenska
Deutsch
Italiano
Español
Norsk
Polski
Nederlands
Português
Japanese
Korean
Russian
0 Items
Print View
