Chapter II: Installation : ViewPlus Tiger Elite and Premier Series Embosser Manual

ViewPlus Tiger Elite and Premier Series Embosser Manual

Print View
Table of Contents
I. Introduction
	-	Preface
	-	FCC Compliance Statement
	-	Safety Instructions
	-	Specifications
II. Installation
	-	Unpacking
	-	Cable Attachment
	-	Software Installation
	-	Alignment
III. Printer Properties
	-	Windows Printer Defaults
	-	Legacy Printer Defaults
	-	Service Settings
IV. Operator Panel
	-	Functions
	-	Displays
	-	Tones
V. Paper Handling
	-	Paper Loading
	-	Paper Jams
VI. Braille, Translation and Printing
	-	ViewPlus Tiger Software Suite
	-	Fonts
	-	Math and Braille
	-	Printing
VII. Support, Maintenance and Warranty
	-	Training and Support Packages
	-	Maintenance
	-	Warranty
	-	Extended Warranty and Maintenance Plan

Chapter II: Installation


A.	Unpacking

	Remove the embosser and all its accessories from its packaging. Inspect the ViewPlus embosser and its packaging for any damage. Save the packing material and box. If any damage occurred during shipping, most shipping companies require the box and the packing material in order to settle the insurance claim. The packing material must also be used to ship the ViewPlus embosser for warranty maintenance service. Follow the ViewPlus Tiger Elite and Premier Setup Instructions included with your other materials.

B.	Cable Attachment

	The ViewPlus Tiger Elite and Premier embossers have a power module with a power socket, on/off switch and a compartment holding two fuses on the back side. A sticker next to the power module indicates what specific fuses are required for the embosser. If the embosser will not power on, it might be necessary to replace the fuses. Shows the power module in the back of the embosser Insert the power cable plug into the ViewPlus Tiger Elite or Premier power connector and the other end of the power cable into a grounded outlet or a surge protector (recommended). Turn the embosser on by pressing the power switch to the On or "I" position. The part of the switch towards the top of the printer should be pressed down. Shows the power switch in the back of the embosser Attach data cable. A USB printer cable was included in your box. To use it, attach the flat end of the USB data cable to the USB port of the computer or print server, and then attach the other end to the embosser. The USB connection is located on the back side of the embosser below the LAN connection. You may also use a LAN cable to connect the ViewPlus Tiger Elite or Premier to your network. The embosser is not shipped with a LAN cable. To use this connection method, attach one end of a LAN cable to the top connection port on the back of the ViewPlus Tiger Elite or Premier and attach the other end to a network data port. Shows the USB and LAN connectors in the back of the embosser

C.	Software Installation

	Please follow the easy steps in the ViewPlus Tiger Elite and Premier Setup Instructions to install your Tiger driver. They can also be found on your installation CD (D:\Docs\Setup\(language code)\index.html).

D.	Alignment

	The ViewPlus Tiger Elite and Premier embossers automatically check alignment for the tactile dots at the beginning of each print job. If the embossed output of your embosser seems to be incorrectly aligned, please ensure that the embosser is on a flat, even surface. It is possible to bend the body of the embosser and cause it to be out of alignment. After a paper jam, it is also possible for the embosser to be incorrectly aligned if you simply continue to print. Start a new print job, allow the ViewPlus Tiger Elite or Premier to automatically align and check the new document to see if the alignment is good. If the embossed dots do not seem to be aligned, please contact ViewPlus Support.